Comparison of solution-blending and melt-intercalation for the preparation of poly(ethylene-co-acrylic acid)/organoclay nanocomposites

Ethylene–acrylic acid copolymers (EAAs) and commercial montmorillonite clays organically modified with dimethyldihydrogenatedtallowammonium ions (Cloisite® 15A and 20A) were used for the synthesis of nanocomposites by melt-compounding, static melting of polymer/clay mixtures and solution-intercalation in order to compare the effectiveness of these procedures and to shed light on the thermodynamics and the kinetics of the intercalation process. The preparation from solution was made by the use of several solvents, such as toluene, xylene, chloroform, etc., which were then removed from the hybrids by precipitation in different non-solvents or by evaporation. Particular attention was paid to the effect of the thermal treatments which are often used when processing the composites prepared from solution. X-ray diffraction (XRD) of the solution-blended composites showed that no intercalation of the EAAs inside the clay galleries can be achieved if solvent removal is made by precipitation in non-solvents or by room-temperature evaporation. On the contrary, intercalation was found to occur very rapidly (in less than 1 min) when both the hybrids prepared from solution and the mechanical blends of powdered components were melted in the absence of shear. Polymer intercalation was also found to occur, though with a lower rate, upon annealing the powder mixtures at temperatures lower than the EAA melting point. Microscopic observations made by polarized optical microscopy, scanning electron microscopy and transmission electron microscopy showed that the clay particles dispersion is appreciably lower for the composites prepared from solution, compared to those produced in the melt under shear flow conditions. The hybrids obtained by static melting of powder mixtures, on the other side, were expectedly found to comprise micron sized clay agglomerates, although intercalation was demonstrated also for these materials by XRD. The structure of the intercalated silicate layers stacks, characterized by an interlayer spacing of 4.0 nm, was shown to be independent of the preparation procedure and to correspond to thermodynamic equilibrium.