Design charts for the general instability of ring-stiffened conical shells under external hydrostatic pressure

The paper describes experimental tests carried out on three ring-stiffened circular conical shells that suffered plastic general instability under uniform external hydrostatic pressure. In this mode of failure, the entire ring–shell combination buckles bodily in its flank. The cones were carefully machined from EN1A mild steel to a very high degree of precision. the results obtained from these three vessels, together with the results obtained from elsewhere, the paper also provides two-design charts, which are much easier to use than older design charts. The design charts allow the possibility of obtaining a plastic knockdown factor, so that the theoretical elastic buckling pressures for perfect vessels, can be divided by the plastic knockdown factor, to give the predicted buckling pressures. Although similar design charts have been produced in the past, the design charts presented here are based on using the simpler ring-stiffened circular cylinder, which has been made equivalent to the much more complex ring-stiffened circular conical shell. The advantage of using this method is that it is simpler and the design time is reduced by a factor of about 10 with little loss of precision. This method can also be used for the design of full-scale vessels.