Effects of CO content on laminar burning velocity of typical syngas by heat flux method and kinetic modeling

Variations in syngas composition could bring a challenge for its combustion with both high efficiency and low emission. In this study, the effect of CO content on the laminar burning velocity of typical syngas was determined by the heat flux method and by kinetic simulations. For the 0% H2 in syngas, the laminar burning velocity increased monotonically with CO content until its maximum value and then dropped rapidly with further increase of CO content, while for the 25% H2 case, the laminar burning velocity increased almost linearly with CO content. Based on the kinetic simulations, consumption rate changes of CO and OH and the discrepancy of the heat release rate in the preheat zone contribute to these trends. At sufficient OH, the increase in the reaction rate between OH and CO corresponds to a faster heat release in the preheat zone, whereas at insufficient OH, oxidation of CO by OH is inhibited and the heat release process is delayed, decelerating the release rate and decreasing the laminar burning velocity.