Title of article
Optimization of 67% Powder Loading Co-30Cr-6Mo μMIM Part by Taguchi Method
Author/Authors
Wahi, Azizah Universiti Kebangsaan Malaysia - Faculty of Engineering and Built Environment - Department of Mechanical and Materials Engineering, Malaysia , Muhamad, Norhamidi Universiti Kebangsaan Malaysia - Faculty of Engineering and Built Environment - Department of Mechanical and Material Engineering, Malaysia , ZAKARIA, HAFIZAWATI Universiti Malaysia Perlis - School of Mechatronic Engineering - Program of Mechanical Engineering, Malaysia
From page
57
To page
60
Abstract
This research studies the effect of injection moulding parameters on the density of green body of Cobalt-30Chromium-6Molybdenum (Co-30Cr-6Mo) for powder injection moulding (PIM) feedstock. In this paper 20 micron Co-Cr-Mo powder was mixed with a palm stearin and polyethylene binder system. L18 orthogonal array by Taguchi Method was used to optimize and predict the future performance. Several injection parameters were optimized such as injection temperature, holding pressure, injection temperature, and mould temperature and injection time. The result shows that the optimum combination of these parameters will produce higher density micro parts. The optimum parameters for 67% powder loading of 20μm Co-30Cr-6Mo powder is 180°C injection temperature, while injection pressure, mold temperature, packing time and injection time are 10 bar, 100°C, 5 s and 7 s respectively.
Keywords
Taguchi method , optimization , injection moulding , green density
Journal title
Jurnal Teknologi :F
Journal title
Jurnal Teknologi :F
Record number
2716492
Link To Document