Effect of relining, water storage and cyclic loading on the flexural strength of a denture base acrylic resin

Objectives This study investigated the effect of relining, water storage and cyclic loading on the ultimate flexural strength (FSU) and on the flexural strength at the proportional limit (FSPl) of a denture base acrylic resin (Lucitone 550-L). Methods Rectangular bars of L were made (64 mm × 10 mm × 2 mm) and relined (1.3 mm) with four relining resins (Kooliner-K, Ufi Gel Hard-UGH, Tokuso Rebase Fast-TR and New Truliner-NT). In addition, specimens relined with L and intact L specimens were made (64 mm × 10 mm × 3.3 mm). A three-point flexural test was applied on the specimens (n = 10) after (1) polymerization; (2) water storage (30 days); (3) cyclic loading (10,000 cycles at 5 Hz) and (4) water storage (30 days) + cyclic loading. Data (MPa) were analyzed with three-way ANOVA and Tukeyʹs HSD tests (α = 0.05). To test for a possible correlation between FSU and FSPl, a linear regression coefficient “r” was calculated. Results After water storage, L-UGH and L-TR demonstrated an increased FSU (41.49–50.64 MPa and 49.95–57.36 MPa, respectively) (P < 0.05). Only L-TR demonstrated an increased FSPl (20.58–24.21 MPa) after water storage (P < 0.05). L-L had the highest FSU (between 78.57 and 85.09 MPa) and FSPl (between 31.30 and 34.17 MPa) (P < 0.05). The cyclic loading decreased the FSU and FSPl of all materials (P < 0.05). Regression analysis showed a strong linear correlation between the two variables (r = 0.941). Conclusions Water storage improved the FSU of L-UGH and L-TR and the FSPl of L-TR. L-L produced the highest FSU and FSPl. The FSU and FSPl of all materials were detrimentally influenced by cyclic loading.