Simulation of corrosion product activity for nonlinearly rising corrosion on inner surfaces of primary coolant pipes of a typical PWR under flow rate transients

For nonlinear accelerating corrosion, calculation of activated corrosion products on inner surfaces of primary coolant pipes have been done in a typical pressurized water reactor (PWR) under flow rate perturbations. Computer program CPAIR-P (Corrosion Product Activity In Reactors) (Deeba et al., 1999) has been modified to accommodate for time-dependent corrosion rates. Results, for 24Na, 56Mn, 59Fe, 58Co, 60Co and 99Mo, show that the specific activity in primary loop approaches equilibrium value under normal operating conditions fairly rapidly. Predominant corrosion product activity during operation is due to 56Mn, and cobalt isotopes dominate the activity after shutdown of reactor. Flow rate perturbations and different types of rising corrosion rates were introduced in the system and effects on saturation activity were studied. For a linear decrease in flow rate and a constant corrosion rate, the total coolant activity and activity on pipe scale approaches higher saturation values when compared to normal condition values. With a nonlinearly accelerating corrosion, the behavior of specific activity changes considerably. The flow rate perturbations on specific activity for pipe scale results in a new saturation value which depends on both the changes in flow rate (Δw) and equilibrium corrosion rate (Cs) values. However, the time taken to reach the saturation activity depends on the slope of corrosion rate. For a slow pump coastdown, the activity does not show an initial drop when flow rate starts decreasing. It monotonically rises and follows the slope of corrosion rate. The peak value and decay of activity after scram are strong functions of flow rate and removal efficiencies.