The influence of punching and laser cutting technologies on the magnetic properties of non-oriented silicon iron steels

Author

Manescu, Veronica ; Paltanea, Gheorghe ; Gavrila, Horia ; Peter, Ioan

Author_Institution

Electr. Eng. Dept., Politeh. Univ. of Bucharest, Bucharest, Romania

fYear

2014

Firstpage

1

Lastpage

4

Abstract

Punching and laser cutting of non-oriented silicon iron sheets (NO FeSi) determine changes in the material at the cutting edge, which produce an important effect on the magnetic properties. Through punching it results a plastic deformation in the zone near the cutting edge. Laser cutting technology causes thermal stresses, which alter also the magnetic properties. The knowledge of the type of deterioration is very important for the production of the electrical machines, because of the increased total losses. There were tested steel samples of NO FeSi grades, M400-65A and M800-65A, with an area of 300 × 30 mm². The magnetic properties were measured with a laboratory single strip tester in the range of frequency from 10 ÷ 400 Hz at 1 T peak magnetic polarization.

Keywords

iron alloys; laser beam cutting; magnetic particles; plastic deformation; punching; sheet materials; thermal stresses; NOFeSi; electrical machine production; laser cutting; magnetic polarization; nonoriented silicon iron steel magnetic properties; plastic deformation; punching; thermal stresses; Energy loss; Laser beam cutting; Magnetic hysteresis; Magnetic properties; Permeability; Punching; Steel; excess losses; hysteresis energy losses; laser cutting; magnetic permeability; non-oriented silicon iron strips; punching; total energy losses;

fLanguage

English

Publisher

ieee

Conference_Titel

Fundamentals of Electrical Engineering (ISFEE), 2014 International Symposium on

Print_ISBN

978-1-4799-6820-6

Type

conf

DOI

10.1109/ISFEE.2014.7050611

Filename

7050611