Simple and rapid methods for the fabrication of polymeric and glass chips for using in analytical chemistry Original Research Article

This paper describes simple and rapid methods for the fabrication of glass and polymeric chips for routine analytical applications. The methods are easily interfaced to the general laboratory environment and do not require special clean room facilities or expensive instruments. Glass microchips were fabricated by etching with HF solution. Microfluidic channels were designed with CAD program and transferred onto a sheet of commercial polymeric self-adhesive (PSA) film by a cutter plotter. The PSA film was used as a mask for etching process. The etching rate was about 7 μm min−1. A cover glass plate was sealed on the top of etched substrate by using polycellulose (cellophane). Polymeric microchips were fabricated by sawing with a jigsaw. Commercial polycarbonate (PC) was used as a substrate and two iron sheets were used as leader masks. While this restricts us to the fabrication of straight channels, it is however, much faster and less complicated than the other methods. The chip comprised three polymeric plates and the channels were created in the middle plate. Thermal bonding was used to bond three layers of the microfluidic chip. With this method, we could achieve simple channels with the width of about 200 μm. The channel depth depends on the polymeric plate thickness. Fabricated channels were accurate without any sinuosity or sideshow.