Turning of glass–fiber reinforced plastics materials with chamfered main cutting edge carbide tools

In this paper, the machinability of high-strength glass–fiber reinforced plastics (GFRP) materials in turning with chamfered main cutting edge of P and K type carbide tools have been investigated experimentally. Chip formation mechanisms have been obtained with respect to tipʹs geometries and nose radii. Experimental results for cutting forces were also taken with GFRP as the workpiece material. Force data from these tests were used to estimate the empirical constants of the mechanical model and verify its prediction capabilities. The results show good agreement between the predicted and measured forces. In this study, the nose radius R = 0.3 mm induces a decrease of the cutting force and the smallest cutting force values was achieved in the case of Cs = 20°, αS1(αS2) = −10°(10°) and R = 0.3 mm. Comparing the different P and K type of tools, K type tool is better than P type of chamfered main cutting edge tools. The theoretical values of cutting forces were calculated and compared with the experimental results; the forces predicted by this model were consistent with the experimental values.