Surface modifications of Al–Zn–Mg alloy using combined EDM with ultrasonic machining and addition of TiC particles into the dielectric

This study proposes a novel combined process that integrates electrical discharge machining (EDM) and ultrasonic machining (USM) to investigate the machining performance and surface modification on Al–Zn–Mg alloy. In the experiment, TiC particles were added into the dielectric to explore the influence of the combined process on the material removal rate (MRR), the relative electrode wear ratio (REWR), the surface roughness and the expansion of the machined hole. The elemental distributions of titanium and carbon on the cross-section were quantitatively determined using an electron probe micro-analyzer (EPMA). Microhardness and wear resistance tests were conducted to evaluate the modifications on the machined surface caused by the combined process. The experimental results show that the combined process was associated with improved machining performance. The combination of EDM with USM yielded an alloyed layer that improved the hardness and wear resistance of the machined surface.