Rapid swelling and deswelling in cryogels of crosslinked poly(N-isopropylacrylamide-co-acrylic)

Thermally sensitive hydrogels of poly[N-isopropylacrylamide (NIPA)-co-acrylic(AA)] hydrogels with N,N-methylene bisacrylamide (BIS) as crosslinker have been synthesised via a two-step procedure in which, the initial polymerisation is conducted for various times at 18 °C, this step being followed by polymerisation for one fixed time at −22 °C. The gravimetrically determined rates of swelling/deswelling for these materials termed “cryogels” prepared by this two-step polymerisation are much higher than those for the same type of hydrogel prepared via conventional methods (30 °C for 24 h). For example the time for the former xerogel to take up 70% of its final water content at 25 °C is just 18 min, compared with a time 300 min for the latter to attain the same uptake of water. During deswelling (shrinking) at 50 °C, which is above the lower critical temperature, the hydrogel loses 60 and 90 wt.% water in 1 and 10 min respectively, compared to a timescale for the corresponding crosslinked copolymers prepared by conventional methods of about 100 min for 50 wt.% water loss. A third type of hydrogel was made by a cold treatment (CT), for which the hydrogel prepared by conventional polymerisation was stored in the frozen state. The swelling rate of these CT xerogels was the same as that for xerogels prepared by conventional polymerisation, but the deswelling rate of the former was higher than that of the latter; for example, during deswelling, a loss of 90% water is attained within a few minutes. Scanning electron microscopy, digital photographs and flotation experiments together with swelling ratio studies reveal that the polymeric network of cryogel produced by the two-step polymerisation method is characterised by an open structure with more pores and higher swelling ratio but lower mechanical strength compared to the conventional hydrogels. The polymerisation was taking place on moderate freezing condition and the hydrogel was stored in a frozen state and subsequent thawing of polymer to be very useful the acceleration the response rate of this kind hydrogels. Such rapid response hydrogels have potential applications in separation and drug release technologies for example.