Modeling the evolution of dislocation populations under non-proportional loading

The two-phase composite approach of describes an evolving dislocation cell structure with dislocation populations for cell walls and the interior. enhanced the model to capture the effects of hydrostatic pressure and temperature during severe plastic deformation. The main goal of the present study is to extend this microstructural model to non-proportional deformation in order to develop a framework suitable for the simulation of dislocation density evolution upon load path changes. Thereby, the two-phase composite approach is examined carefully. Both physical and numerical drawbacks are revealed and possible solutions are presented. Here, a special aim is to ensure that values of the dislocation densities remain within a physically reasonable range. Moreover, some improvements concerning reliable parameter identification are suggested as well. The material parameters are identified for an aluminum alloy using TEM cell size measurements. The extension to non-proportional deformation aims to predict the experimentally observed dissolution of cells and reduction of total dislocation density shortly after load path change. In order to capture these effects, some tensor-valued state variables are introduced which couple the refined micro model with the macroscopic viscoplasticity framework proposed by . As a result, a new system of constitutive equations is obtained. In order to demonstrate the framework’s capability to respond to load path changes, load cases as typical for Equal Channel Angular Pressing (ECAP) are considered. The obtained evolution of dislocation populations differs significantly depending on which ECAP route is applied.