Experiments with micro-fin tube in single phase

This work shows heat transfer and friction characteristics for water single-phase flow in micro-fin tubes. The analysis of thermal and hydraulic behavior from a laminar to a turbulent flow was carried out in an experimental setup with a 9.52 mm diameter micro-fin tube. The tube was wrapped up with an electrical resistance tape to supply a constant heat flux to its surface. Different operational conditions were considered in the heating tests. The inlet and outlet temperatures, differential wall temperatures along the tube, pressure drop and flow rate were measured. The relationships of heat flux and flow rate with heat transfer coefficient and pressure drop were analyzed. Under the same conditions, comparative experiments with an internally smooth tube were conducted. The micro-fin tube provides higher heat transfer performance than the smooth tube (in turbulent flow hmicro-fin/hsmooth=2.9). In spite of the increase in pressure drop (Δpmicro-fin/Δpsmooth=1.7) the heat transfer results were significantly higher (about 80%). This shows the advantages of this enhanced configuration in thermal performance related to conventional tubes. The smooth tube results were validated by the comparison with the Dittus–Boelter and Gnielinski correlations. For the micro-fin tube an empirical correlation to the heat transfer coefficient adjusted from the set of measured data is proposed. The values obtained are in conformity with experimental results.