Mechanical behaviour and 3D stress analysis of multi-layered wooden beams made with welded-through wood dowels Review Article

This paper presents experimental and numerical investigations on multi-layered timber beams using welded-through wood dowels in place of traditional poly(vinyl acetate) (PVAc)-adhesives (or metallic nails). Four-layer beams were constructed with varying numbers of dowels, in each, and then loaded using four-points bending tests to evaluate the mechanical performance of these beams. The practical difficulties encountered in constructing deeper multi-layer beams are discussed and possible solutions which have been employed for the purpose of this work, and proved successful are presented. In order to investigate thoroughly the full potential of multi-layered beams with a very limited number of experimental studies, a 3D FE model has been presented, validated against experimental results and then used to study some influential parameters. The results showed that a reasonable bending stiffness of multi-layered beams is achievable with a good combination of material and geometric parameters.