Experimental studies on rewetting of hot vertical annular channel

Considering the hypothetical core melt down scenario for a light water reactor (LWR) the failure mode of the reactor pressure vessel (RPV) has to be investigated to determine the loadings on the containment. The failure of reactor vessel retention (FOREVER)-experiments, currently underway, are simulating the thermal and pressure loadings on the lower head for a melt pool with internal heat sources. Due to the multi-axial creep deformation of the vessel with a non-uniform temperature field these experiments are an excellent source of data for validation of numerical creep models. Therefore, a finite element (FE) model has been developed based on a commercial multi-purpose code. Using the computational fluid dynamics (CFD) module the temperature field within the vessel wall is evaluated. The transient structural mechanical calculations are performed using a new numerical approach, which avoids the use of a single creep law employing constants derived from the data for a limited stress and temperature range. Instead of this a three-dimensional array is developed where the creep strain rate is evaluated according to the values of the actual total strain, temperature and equivalent stress. Care has to be exercised performing post-test calculations particularly in the comparisons of the measured data and the numerical results. Considering the experiment FOREVER-C2, for example, the recorded creep process appears to be tertiary, if a constant temperature field is assumed. But, small temperature increase during the creep deformation stage could also explain the observed creep behavior. Such considerations provide insight and better predictive capability for the vessel creep behavior during prototypic severe accident scenarios.