The collection efficiency of a particle-loaded single filter fiber

The collection efficiency η(M) of single fibers, both isolated and within a parallel array, was determined as a function of accumulated particle mass for Stokes numbers St=0.3–3 and interception parameters In=0.04–0.32. This regime is dominated by inertia, interception and particle bounce. Measurements were made with an optical in-situ particle counting technique. Monodisperse polystyrene aerosols (1.3, 2.6, 3.6 and 5.2 μm) were deposited onto steel wires of 8 and 30 μm, respectively. Particle accumulation reached values on the order of M=0.5–1 μg/mm fiber, corresponding to 104–106 particles per mm, depending on size. as found to increase for all operating conditions between about 2 and nearly 50 fold, most strongly however for those conditions were the bare fiber is ineffective as a particle collector, i.e. for very low or very high values of St number, corresponding to low collision or low adhesion probabilities, respectively. The absolute efficiency increased to values approaching or exceeding unity, i.e. the effective fiber collision cross-section exceeded the diameter of the bare fiber. For fibers within an array of parallel fibers (equivalent packing density ∼0.004), the initial efficiency η0 was higher than for an isolated fiber by almost an order of magnitude. However the increase with loading was substantially smaller, typically by an order of magnitude. ficiency increase can be described by a power law of the type eta ( M ) / η 0 = 1 + b · M c where b and c are empirical fit coefficients. Within an array, the exponent c is on the order of 0.7±0.05, but lower than reported in earlier work on fiber arrays which suggest a value near unity. For isolated fibers, c→1 as interception becomes dominant (at very low flow velocities) while at high impact velocities and significant particle bounce c≈0.5. The coefficient c correlates with fiber Reynolds number, but not with other parameters. The coefficient b is inversely proportional to η0 (consistent with earlier work, however with significantly lower values than previously published) and a function of (St/R)2. perimental section of the paper is preceded by a literature review on single-fiber efficiency data and models for the inertia-interception regime, including both information on bare fibers and dust loaded fibers. An improved, general fit function with physically meaningful limits for St→0 and St→∞ is proposed for the efficiency of bare fibers.