Emissions from a diesel car during regeneration of an active diesel particulate filter

The California Air Resources Board (CARB) and the Joint Research Center of the European Commission (JRC) have collaborated on emissions testing of a light duty diesel vehicle, which is Euro 4 compliant and comes equipped with a diesel particulate filter (DPF). The California testing included an investigation of the regeneration of the DPF over cruise conditions and NEDC test cycles. DPF regeneration is caused by the buildup of soot in the filter, and for the present test vehicle the regeneration process is assisted by a fuel borne catalyst. Regulated exhaust emissions increased substantially during the regeneration events; however, PM emissions levels were below California LEVII emissions standards. There was a very large increase of volatile particles between 5 and 10 nm, and these volatile particles were generated during all of the observed regeneration events. It appears that the particle number instruments that use the PMP methodology do not capture the PM mass increase during DPF regeneration; however, for one regeneration event there was an apparent large increase in solid particles below the PMP size limit. The PM mass increase associated with regeneration appears to be due to semi-volatile particles collected on filters. During the testing, the regeneration events exhibited considerable variations in the time for regeneration as well as the amount of PM emissions. From this investigation, several questions have been posed concerning the emission of very small (<20 nm) volatile and solid particles during DPF regeneration that need further investigation.