Friction and wear behaviors of a (Ca, Mg)-sialon/SAE 52100 steel pair under the lubrication of various polyols as water-based lubricating additives

The friction and wear behaviors of (Ca, Mg)-sialon/SAE 52100 steel pair under the lubrication of water or various polyol aqueous solutions were investigated with an SRV friction and wear tester in a ball-on-disc configuration. This was conducted to simulate the effect of polyols as aqueous additive in machining sialon ceramic. The morphologies of and elemental distributions in the worn surfaces of the lubricated sialon ceramics and counterpart steel were observed and determined with scanning electron microscopy (SEM) and electron probe microanalysis (EPMA). All solutions of the tested polyols decreased the friction coefficient of (Ca, Mg)-sialon/SAE 52100 steel effectively and increased the wear volume loss of (Ca, Mg)-sialon to some extent as compared with dry sliding. The friction coefficients under the lubrication of distilled water and various polyols aqueous solutions of polyols showed almost no difference, and propanetriol was found to be the most effective for machining (Ca, Mg)-sialon with the concentration of polyols in water fixed as 5 wt%. The friction coefficients under the lubrication of propanetriol aqueous solutions in varied concentrations are closely related with the concentration, which came to the lowest value of 0.04 at a concentration of 75%. The friction-reducing performance of the polyols as additives in water was roughly correlated with their wetting behaviors on the sialon ceramic surface. In other words, the higher the wetting ability is, the lower the friction coefficients will be. Moreover, the wear volume losses of (Ca, Mg)-sialon also varied with the variation in the concentration of propanetriol in water. Accounting for the friction-reduction and wear behavior, 20% concentration of propanetriol in water could be recommended for machining (Ca, Mg)-sialon. Electron microscopic analysis indicates that polyols as additives in water enhanced the corrosive wear of sialon ceramic, which could be beneficial for increasing the machining efficiency. There existed interactions among water, polyols and sialon surfaces, which were dependent on the compositions of the lubricant solution. This accounts for the variations in the friction and wear behaviors with the concentration of polyols in water.