Influence of temperature distributions in EHL film on its thickness under high slip ratio conditions

This paper describes the influence of temperature rise of oil film in Hertzian contact area on the film thickness or profile under high slip ratio conditions. Temperatures of both surfaces of a ball and a disk as well as average temperature across the oil film were measured by means of an improved infrared. Two kinds of optical band-pass filters were used to separate the radiations from the ball surface and the oil film through an infrared transparent disk made of sapphire glass. In case of temperature measurement of the disk surface, another sapphire glass disk was coated with 300 nm chromium layer on the contact surface to radiate the infrared from the disk surface and also to intercept the radiation from the ball surface and the oil film. Temperature profiles across the oil film were estimated by assuming a parabolic profile with the measured three kinds of temperatures. se within 200% in slip ratio, both minimum and central film thickness decreased under constant entrainment velocity as slip ratio increased. Measured film shapes were not flat at central Hertzian contact region under high-slip condition and differed from the results by the conventional EHD theory assuming constant viscosity in the direction of film thickness. The profile of Couette flow varied due to the distribution of oil film temperature in thickness direction. The viscosity wedge action, that is the variation of the profile of Couette flow causes reduction of film thickness or deformation of film profile. For case over 200% in slip ratio, the relation between central film thickness and slip ratio under constant relative slide speed had a great difference from the results calculated from the formula presented by Chittenden et al.