Effect of directional solidification and heat treatments on the microstructure and mechanical properties of multiphase intermetallic Zr-doped Ni–Al–Cr–Ta–Mo alloy

The effect of directional solidification and heat treatments on the microstructure and mechanical properties of intermetallic Ni–21.29Al–7.04Cr–1.46Ta–0.64Mo–0.57Zr (at.%) alloy was studied. Increasing growth rate is found to decrease primary dendrite arm spacing and to increase volume fraction of β(NiAl)-based dendrites and low melting point γ′(Ni3Al)/Ni5Zr eutectic. Room-temperature tensile yield strength and ultimate tensile strength increase and plastic elongation to fracture decreases with the increasing growth rate. Two types of heat treatments of directionally solidified (DS) specimens including two-step ageing at temperatures of 1273 and 1123 K and two-step solution annealing at 1373 and 1493 K were performed. Ageing at 1273 and 1123 K decreases volume fractions of the dendrites and eutectic regions and leads to a coarsening of spherical α-Cr and needle-like γ′ precipitates within the β-phase. Annealing at 1373 K for 100 h is shown to be sufficiently long to completely dissolve the eutectic regions. Compressive yield strength increases with increasing temperature reaching a peak value at about 1023 K and then decreases at higher temperatures. Minimum creep rate is found to depend strongly on the applied stress and temperature according to a power law. The power law stress exponent n is determined to be 5.1 and apparent activation for creep Qa is measured to be 326 kJ/mol.