Creep behaviour of a new air-hardenable intermetallic Ti–46Al–8Ta alloy

Creep behaviour of a new cast air-hardenable intermetallic Ti–46Al–8Ta (at.%) alloy was investigated. Constant load tensile creep tests were performed at initial applied stresses ranging from 200 to 400 MPa in the temperature range from 973 to 1073 K. The minimum creep rate is found to depend strongly on the applied stress and temperature. The power law stress exponent of the minimum creep rate is n = 5.8 and the apparent activation energy for creep is calculated to be Qa = (382.9 ± 14.5) kJ/mol. The kinetics of creep deformation of the specimens tested to a minimum creep rate (creep deformation about 2%) is suggested to be controlled by non-conservative motion of dislocations in the γ(TiAl) matrix. Besides dislocation mechanisms, deformation twinning contributes significantly to overall measured strains in the specimens tested to fracture. The initial γ(TiAl) + α2(Ti3Al) microstructure of the creep specimens is unstable and transforms to the γ + α2 + τ type during creep. The particles of the τ phase are preferentially formed along the grain and lamellar colony boundaries.