Tailoring the properties of yttria-stabilized zirconia powders prepared by the sol–gel method for potential use in solid oxide fuel cells

Yttria-stabilized zirconia (YSZ) powders have been prepared by the sol–gel method, following two alternative procedures: a series of powders was obtained by drying the sol–gel solutions in air at 100 °C until dry residue, and another series of powders was obtained by scratching the thin films deposited on cylindrical wide flat glassy surfaces after evaporating to dryness in air at 100 °C for 2 h. Samples were characterized by Scanning Electron Microscopy (SEM), nitrogen adsorption at −196 °C and Fourier Transform Infrared (FT-IR) spectroscopy. In general, a noticeable contraction of the pores is observed as the molecular size of the alcohols used grows. Powders prepared by conventional drying of sol–gel solutions at 100 °C exhibit remarkably high values of specific surface area (up to 148 m2 g− 1). On the contrary, samples prepared by scratching of the deposited thin films show a noticeable decrease in their specific surface area. Values of fractal dimension follow the same trend and indicate that, in general, the texture of the samples is mainly microporous for the first series of samples and more ordered for the second one. Finally, in order to investigate the effect of the calcination temperature on the morphological and textural properties of 3 mol% yttria-stabilized zirconia powders, once the 3YSZ powders were dried at 100 °C they were subjected to calcination at different temperatures. The experimental results suggest that the removal of residual water and alcohol occluded within the powder particles as well as the elimination of gases produced during the calcination stage play a very important role in the development of the porosity and surface area of the samples.