Micellar electrokinetic chromatography at low pH with polyelectrolyte-coated capillaries

The performance of capillaries coated with a poly(diallyldimethylammonium) (PDADMA) monolayer or poly(diallyldimethylammonium)–poly(styrenesulfonate) bilayer was investigated and compared under micellar electrokinetic chromatographic (MEKC) conditions. Both monolayer (positively charged) and bilayer (negatively charged) coatings with micellar (sodium dodecyl sulfate) electrolyte generated very stable and pH-independent cathodal electroosmotic flow (EOF). From the results obtained, it can be concluded that in a doubly coated capillary the second poly(styrenesulfonate) layer is replaced by sodium dodecyl sulfate micelles during flushing with micellar electrolyte. Consequently, in order to obtain a stable and pH-independent cathodal electroosmotic flow for the MEKC separations, the capillary coating with the second polyanion layer is not necessary. The importance of the PDADMA coating was illustrated by comparing MEKC separations of the common developing agents (hydroquinone, phenidone, pyrocatechol, pyrogallol and quinone) on a bare uncoated capillary with the coated capillary. The coating provides reproducible MEKC separations at low pH (pH 3.0) with relative standard deviation (R.S.D.) values for migration times and peak areas lower than 0.45 and 3.3%, respectively. Good linearities in the range from 5 × 10−5 to 2 × 10−3 mol l−1 were obtained for all five compounds, with correlation coefficients higher than 0.998. The detection limits were in the range from 5 × 10−6 mol l−1 for pyrocatechol to 2 × 10−5 mol l−1 for quinone. The proposed MEKC system was applied to the determination of hydroquinone and phenidone in X-ray photographic developer solutions.