Bearing capacity of a square model footing on sand reinforced with shredded tire – An experimental investigation

Recycling rubber from waste tires has become one of the major challenges worldwide. The use of waste tires in geotechnical applications may be feasible as an alternative way to consume the huge stockpile of scrap tire, with a better understanding of the behavior of rubber–soil mixture. The objective of this study was to investigate the feasibility of using rubber shreds, randomly distributed into the soil, as soil reinforcement beneath the footing. A series of laboratory tests were conducted to obtain the bearing capacity of a square footing rested on shredded rubber-reinforced soil. The results show that the efficiency of rubber reinforcement was increased by addition of rubber content, the thickness of rubber-reinforced soil layer and the soil cap thickness up to the optimum values of these parameters, after that, with a further increase in each of these parameters, the bearing capacity decreases. For the optimum value of rubber content of 5% at footing settlement level of 5%, the maximum improvement in bearing capacity of rubber-reinforced bed was obtained as 2.68 times of the unreinforced bed. This value of improvement was achieved using the optimum thickness of reinforced layer of 0.5 times of footing width and the optimum thickness of soil cap of 0.25 times of footing width. The findings strongly suggest the use of rubber shreds obtained from non-reusable tires as a viable alternative way for improving the soil behavior, particularly when environmental interest is considered.