Hydrogen electrosorption in nanocrystalline Ti-based alloys

The electrochemical behavior in alkaline solution (1 M NaOH) of nanocrystalline Ti:Ru:Fe:O (2:1:1:2) prepared by high-energy ball milling was studied over its whole electroactivity domain, with a particular emphasis on the hydrogen evolution reaction (her). Comparison has also been made with nanocrystalline Ti:Ru:Fe (2:1:1) and a mixture of Ti:TiO:Ru:Fe2O3 (3/2:1/2:1:1/2). It was shown by cyclic voltammetry, open circuit potential decay and chronopotentiometry measurements that hydrogen absorption in the electrode material occurs during hydrogen discharge. The electrochemical behavior of nanocrystalline Ti:Ru:Fe:O (2:1:1:2) closely follows that of Ti:Ru:Fe (2:1:1), but differs radically from that of Ti:TiO:Ru:Fe2O3 (3/2:1/2:1:1/2). This is due to the fact that the former two compounds contain a significant fraction of B2 phase (59 and 97 wt.%, respectively), while the latter does not. In steady state conditions, the ratio H/B2 phase in nanocrystalline Ti:Ru:Fe:O (2:1:1:2) is 0.15, about 1.6 times less than that for the O-free nanocrystalline compound. The coefficient of diffusion of hydrogen in nanocrystalline Ti:Ru:Fe:O (2:1:1:2) is 2.6×10−13 cm2 s−1, more than three times less than that in nanocrystalline Ti:Ru:Fe (2:1:1). The difference between the hydrogen absorption characteristics of both nanocrystalline compounds are tracked down to the fact that their B2 phases have different stoichiometries.