Title of article :
Experimental study of powder bed behavior of sodium alanate in a lab-scale H2 storage tank with flow-through mode
Author/Authors :
Utz، نويسنده , , I. and Linder، نويسنده , , M. and Schmidt، نويسنده , , N. and Hu، نويسنده , , J.J. and Fichtner، نويسنده , , M. and Wِrner، نويسنده , , A.، نويسنده ,
Issue Information :
روزنامه با شماره پیاپی سال 2012
Pages :
9
From page :
7645
To page :
7653
Abstract :
Chemical hydrogen storage in complex hydrides offers the potential of high gravimetric storage densities compared to intermetallic hydrides, and is therefore a promising technology for mobile applications. The main challenge for mobile application is still the required high refuelling rate of the hydrogen storage tanks. Since hydrogen is bonded by an exothermal chemical reaction in complex hydrides, appropriate storage tanks require high heat transfer rates for the cooling of the tank. Hydride tanks that are state of the art rely on an indirect cooling and are additionally equipped with e.g. finns, foams, etc. to improve the heat transfer rate. For the present study, an improved laboratory tank, which allows for indirect as well as direct cooling by excess H2 gas (flow-through mode), has been designed and built. This laboratory tank is filled with 87 g of NaAlH4 (doped with 2 mol% CeCl3) and equipped with 8 thermocouples as well as two pressure sensors. Experimental results presented in this paper show a significant influence of the cooling by gaseous excess H2 on the flow-directional temperature profiles at the part of the reaction bed close to the inlet. Considering the overall conversion, this influence is rather small due to the low heat capacity flux (ρ cp)H2. Furthermore, it is shown that changes in material properties, attributed to the effects of heat and mass transport as well as intrinsic reaction kinetics, can be measured and assessed by the temperature and pressure sensors. After about 10 complete charging and discharging cycles, the initial permeability K of the bed has decreased by 50% to 1.6·10−12 m2. In the same time, the initial thermal conductivity has increased by a factor of 1.3 to values reported in literature (0.67 Wm−1 K−1) and remains constant during further cycles. Additionally, it is observed that the reaction rate of the second absorption step improves, even after a total of 36 cycles.
Keywords :
reactor design , Hydrogen storage , Direct heat transfer , cycling stability , Sodium alanate
Journal title :
International Journal of Hydrogen Energy
Serial Year :
2012
Journal title :
International Journal of Hydrogen Energy
Record number :
1671303
Link To Document :
بازگشت