Determination of total arsenic by batch hydride generation atomic absorption spectrometry in injectable drugs containing high levels of Sb(V) as N-methylglucamine antimonate

A procedure for the determination of arsenic by batch hydride generation atomic absorption spectrometry (HG AAS) in commercial samples of injectable drugs, containing high concentrations of Sb(V), is described. The procedure is based on the complexing effect for Sb of citric, oxalic and acetic acids as reaction media. Aqua regia was used for sample digestion prior to As determination by HG AAS. The following experimental conditions for the determination of total As, as As(V), were evaluated: the acid medium and its concentration, sodium tetrahydroborate concentration, purge time, and influence of the different oxidation states of As. The effect of the delay time after mixing of sample and acid solution was also studied. Optimized conditions were: 10% (m/v) citric acid, 1.5% (m/v) sodium tetrahydroborate solution and 30 s for purge time. A delay time of 1 h was required after the digested sample had been mixed with citric acid, before As determination could be carried out. No interference on As(III) and As(V) signals was observed in the presence of up to 1 mg Sb(V). The tolerance limits for Ni(II), Cu(II) and Pb(II) were 1 mg, 100 μg and 100 μg, respectively. Recovery tests for As(III) and As(V) resulted in values between 97 and 101%. Characteristic mass and detection limit (3σ), using the recommended conditions, were 0.52 and 0.8 ng, respectively, for total As.