Microstructures and mechanical properties of polypropylene/polyamide 6/polyethelene-octene elastomer blends

A series of polymer blends were designed and manufactured. They are composed of three phases: polypropylene (PP), polyamide-6 (PA6) and polyethylene-octene elastomer (POE) grafted with maleic anhydride. The weight fraction of PA6 was adjusted from 0 to 40% by increments of 10%, and the weight fraction of POE was systematically half that of PA6. The morphology, essentially made of PA6 particles dispersed in the PP matrix, was characterised by scanning electron microscopy (SEM) and transmission electron microscopy (TEM). In the extruded plates prepared with the blends, the shape of the dispersed PA6 particles showed an elongated ellipsoidal shape, whose aspect ratio increased somehow with alloying content. The POE modifier was observed both as a thin interlayer (less than 100 nm thickness) at the PP/PA6 interface, and as a few isolated particles. The elastic modulus and yield stress in tension are nearly constant for PP and blends. By contrast, the notched Izod impact strength increases very much with alloying content. This remarkable effect is interpreted in terms of POE interphase cavitation, enhanced plastic shear deformation and resistance of PA6 particles to crack propagation.