Anticorrosively enhanced PMMA–SiO2 hybrid coatings prepared from the sol–gel approach with MSMA as the coupling agent

A series of sol–gel derived organic–inorganic hybrid coatings consisting of organic poly(methyl methacrylate) (PMMA) and inorganic silica (SiO2) were successfully synthesized by using 3-(Trimethoxysilyl)propyl methacrylate as a coupling agent. In this work, MSMA is first copolymerized with methyl methacrylate monomer at specific feeding ratio by using benzoyl peroxide (BPO) as initiator. Subsequently, the as-prepared copolymer (i.e., sol–gel precursor) is then cohydrolyzed with various contents of tetraethyl orthosilicate (TEOS) to afford chemical bondings to the forming silica networks, giving a series of hybrid sol–gel coatings. Transparent organic–inorganic hybrid sol–gel coatings with different contents of silica are always achieved. The as-synthesized hybrid sol–gel materials were subsequently characterized by Fourier-Transformation infrared (FTIR) spectroscopy and transmission electron microscopy (TEM). brid sol–gel coatings with low silica loading (e.g., 5 wt.%) on cold-rolled steel (CRS) coupons were found much superior in anticorrosion efficiency over those of neat PMMA based on a series of electrochemical measurements of corrosion potential, polarization resistance, corrosion current, and corrosion rate in 5 wt.% aqueous NaCl electrolyte. The enhancement of corrosion protection effect of hybrid sol–gel coatings may be due to the increase of adhesion strength of hybrid sol–gel coatings on CRS coupons relative to neat PMMA, which was further evidenced by the Scotch tape test evaluation. The increase of adhesion strength of hybrid sol–gel coatings on CRS coupons may be attributed to the formation of Fe–O–Si covalent bonds at the interface of coating/CRS system based on the FTIR–RAS (reflection absorption spectroscopy) studies. Effects of the material composition on the thermal stability, mechanical strength, wettability, and surface morphology of neat copolymer and a series of hybrid sol–gel materials, in the form of coating/film, were also studied by thermogravimetric analysis (TGA), differential scanning calorimetry (DSC), hardness tests, contact angle measurement, and atomic force microscopy (AFM), respectively.