R&D of copper beam duct with antechamber scheme for high-current accelerators

A beam duct with an antechamber scheme for high-current accelerators was designed and the test chambers were studied experimentally. The duct consists of two channels, i.e., a beam channel where a beam circulates and a Synchrotron Radiation (SR) channel (antechamber) aside where the SR passes through. By using the antechamber scheme, the maximum power density of SR can be diluted at the side wall. The impedance is small owing to the pumping ports not being at the beam channel, but at the SR channel. Photoelectrons inside the beam channel are also expected to be reduced, which would be a big merit for a positron ring to suppress the electron cloud effect since the photoelectron is a major source of electrons composing the cloud. Two copper test chambers were manufactured with different methods, by pressing and by drawing. These chambers showed a good static vacuum property, i.e., gas desorption rates with less than 3.5 × 10 - 9 Pa m 3 s - 1 m - 2 after baking. After the installation to the positron ring of the KEK B-factory (KEKB), electron numbers in the beam channel, temperatures and pressures were measured during beam operation. The electrons in the beam channel were found to be reduced by a factor of 4 at 1.5 A compared to the case of the usual circular chamber. The reduction, however, was much larger, about 1/300, at a beam current of about 20 mA where the photoelectrons were dominant and the multiplication of electrons by the multipactoring was small. The temperatures were almost in agreement with the expectation. Vacuum scrubbing by photons proceeded almost smoothly, although pressure bursts were sometimes observed, especially for one test chamber, which was possibly due to discharges at the transverse joints in the beam chamber. Various instructive information had been obtained for future practical beam ducts for high-intensity accelerators.