Author/Authors :
Abdesselam، نويسنده , , A. L. Adkin، نويسنده , , P.J. and Allport، نويسنده , , P.P. and Alonso، نويسنده , , J. and Andricek، نويسنده , , L. and Anghinolfi، نويسنده , , F. and Antonov، نويسنده , , A.A. and Apsimon، نويسنده , , R.J. and Atkinson، نويسنده , , T. T. Batchelor، نويسنده , , L.E. and Bates، نويسنده , , R.L. and Beck، نويسنده , , G. and Becker، نويسنده , , H. and Bell، نويسنده , , P. and Bell، نويسنده , , W. and Bene?، نويسنده , , P، نويسنده ,
Abstract :
The challenges for the tracking detector systems at the LHC are unprecedented in terms of the number of channels, the required read-out speed and the expected radiation levels. The ATLAS Semiconductor Tracker (SCT) end-caps have a total of about 3 million electronics channels each reading out every 25 ns into its own on-chip 3.3 μ s buffer. The highest anticipated dose after 10 years operation is 1.4 × 10 14 cm - 2 in units of 1 MeV neutron equivalent (assuming the damage factors scale with the non-ionising energy loss). The forward tracker has 1976 double-sided modules, mostly of area ∼ 70 cm 2 , each having 2 × 768 strips read out by six ASICs per side. The requirement to achieve an average perpendicular radiation length of 1.5% X 0 , while coping with up to 7 W dissipation per module (after irradiation), leads to stringent constraints on the thermal design. The additional requirement of 1500 e - equivalent noise charge (ENC) rising to only 1800 e - ENC after irradiation, provides stringent design constraints on both the high-density Cu/Polyimide flex read-out circuit and the ABCD3TA read-out ASICs. Finally, the accuracy of module assembly must not compromise the 16 μ m ( r φ ) resolution perpendicular to the strip directions or 580 μ m radial resolution coming from the 40 mrad front-back stereo angle.
l of 2210 modules were built to the tight tolerances and specifications required for the SCT. This was 234 more than the 1976 required and represents a yield of 93%. The component flow was at times tight, but the module production rate of 40–50 per week was maintained despite this. The distributed production was not found to be a major logistical problem and it allowed additional flexibility to take advantage of where the effort was available, including any spare capacity, for building the end-cap modules. The collaboration that produced the ATLAS SCT end-cap modules kept in close contact at all times so that the effects of shortages or stoppages at different sites could be rapidly resolved.
Keywords :
ATLAS , microstrip , SCT , Module , Silicon , LHC