Numerical investigation of macro- and micro-mechanics of a ceramic veneer bonded with various cement thicknesses using the typical and submodeling finite element approaches

Objectives tudy investigates the influence of cement thickness on the macro- and micro-mechanical responses in a ceramic veneer adjacent to an incisal overlapped incisor. s finite element (FE) ceramic veneer macro-models with different cement thicknesses (10–180 μm) were generated. A 10 N load was applied with an angulation of 60° to the longitudinal tooth axis. Seven FE micro-models corresponding to the macro-models were constructed at an enamel–adhesive interface where the stress concentration was found. Based on an interfacial scanning electron microscope (SEM) micrograph, morphology of resin tags in the micro-models was generated. The micro-model boundary conditions were determined from the macro-model results. The principal stress on each node in the macro- and micro-models was calculated to investigate interfacial mechanics. A tensile test was performed to obtain an ultimate cement tensile strength to determine the material failure parameters. s ghest stress concentration within the cement was found at the resin tag base of the enamel–adhesive interface in lingual side. Maximum stress values from 10.6 to 14.7 MPa for the micro-models were higher (44–48%) than that from 7.2 to 10.0 MPa for the macro-models when the cement layers increased. Based on the ultimate tensile strength (11.8 MPa), bonding failure could found when the micro-models with the cement layers presented more than about 50 μm. This seems to correspond with data from previous studies. sions stresses develop in the adhesive as the cement thickness increases. Cement thicknesses less than 50 μm might reduce the adhesive bonding failure.