Title of article
Hole-injection properties of annealed polythiophene films to replace PEDOT–PSS in multilayered OLED systems
Author/Authors
Ohshita، نويسنده , , Joji and Tada، نويسنده , , Yosuke and Kunai، نويسنده , , Atsutaka and Harima، نويسنده , , Yutaka and Kunugi، نويسنده , , Yoshihito، نويسنده ,
Issue Information
دوماهنامه با شماره پیاپی سال 2009
Pages
4
From page
214
To page
217
Abstract
Hole-injection properties of annealed poly(alkoxy- and alkylthiophene) films in OLEDs were studied. Among them, annealed poly(3,3′-dihexyloxy-2,2′-bithiophene) (aPHOBT) film exhibited good hole-injection properties and a triple-layered OLED with the structure ITO/aPHOBT/PVK/Alq3/Mg–Ag (device I) showed much higher performance than a double-layered device without the aPHOBT layer (device II, ITO/PVK/Alq3/Mg–Ag). Device I was slightly inferior to a device having a PEDOT–PSS layer as the hole injector (device III, ITO/PEDOT– PSS/PVK/Alq3/Mg–Ag) in the low-intermediate region of the applied voltage (6–11 V), but gave comparable luminance to III when the applied voltage exceeded 11 V.
Keywords
Annealing , Polythiophene , OLED , Hole-injection
Journal title
Synthetic Metals
Serial Year
2009
Journal title
Synthetic Metals
Record number
2084751
Link To Document