Influence of the microstructure on the plastic behaviour of duplex stainless steels

Microstructure change of α (ferrite) + γ (austenite) two-phase structure in duplex stainless steels deformed by hot torsion tests is briefly analyzed. Two types of stainless steels containing different volume fractions of ferrite and austenite were torsion deformed at temperatures ranging from 900 to 1250 °C. Steel A (25.5Cr–4.9Ni–1.6Mo) contained Creq/Nieq = 4.8 and steel B (22.2Cr–5.6Ni–3Mo) contained Creq/Nieq = 3.5 bring about different microstructures and flow stress behaviour. The results show that the shape of the flow stress curves depends on the material and on deformation conditions. Four different flow curve shapes were observed. At high temperatures, steel A displayed a plastic behaviour typical of ferritic stainless steels. As the deformation temperature decreased, the flow curves presented peak stresses at low-temperature deformation. When the austenite particles are distributed coarsely in the matrix (steel B), the plastic flow curve displays a stress peak separating extensive regions of hardening and softening. When both phases have the same volume fractions, the microstructure is characterized by percolation of the two phases in the samples, and the plastic flow curve takes on a very distinctive shape in hot torsion tests. The role of the microstructure present during deformation on the shape of the flow stress curves is analyzed.