Fluidelastic instability study in a rotated triangular tube array subject to two-phase cross-flow. Part I: Fluid force measurements and time delay extraction

Fluidelastic instability is a key issue in steam generator tube bundles subjected to cross-flow. The extension to two-phase flow of the existing theoretical models, developed and tested mostly for single phase flow, is investigated in this paper. The time delay is one of the key parameter for modeling fluidelastic instability, especially the damping controlled mechanism. The direct measurement of the time delay between the tube motion and the fluid force faces certain difficulties in two-phase flow since the high turbulence due to the interaction of the two components of the flow may increase the randomness of the measured force. To overcome this difficulty, an innovative method for extracting the time delay inherent to the quasi-steady model for fluidelastic instability is proposed in this study. y, experimental measurements of unsteady and quasi-static fluid forces (in the lift direction) acting on a tube subjected to air–water two-phase flow were conducted. The unsteady fluid forces were measured by exciting the tube using a linear motor. These forces were measured for a wide range of void fractions, flow velocities and excitation frequencies. The experimental results showed that the unsteady fluid forces could be represented as single valued function of the reduced flow velocity. It was also found that for a given frequency, the unsteady fluid force phase was weakly dependent on the void fraction for the range of flow velocities considered. me delay was determined by equating the unsteady fluid forces with the quasi-steady forces. The results given by this innovative method of measuring the time delay in two-phase flow were consistent with theoretical expectations. The time delay could be expressed as a linear function of the convection time and the time delay parameter was determined for void fractions ranging from 60% to 90%.