Phase separation, fluid mixing, and origin of the greisens and potassic episyenite associated with the ءgua Boa pluton, Pitinga tin province, Amazonian Craton, Brazil

Based on petrographical data, three types of greisen have been characterized at the western border of Água Boa pluton: siderophyllite–topaz–quartz greisen (greisen 1), fluorite–phengite–quartz greisen (greisen 2) and quartz–chlorite–phengite greisen (greisen 3). Episyenites were also identified. uids of independent origin interacted with the same protolith – a hornblende-biotite alkali feldspar granite – and produced both the greisens and potassic episyenite: (1) an acid, low-salinity (4–12 wt.% NaCl eq.), F-rich, relatively hot (400–350 °C) reduced aqueous-carbonic fluid (CH4–H2O–NaCl–FeCl2 ± KCl), which by immiscibility gave rise to fluid IA (aqueous) and IC (carbonic); and (2) a lower salinity (2–4 wt.% NaCl eq.) and temperature (200–150 °C) aqueous fluid (H2O–NaCl), which was responsible for all dilution processes. Fluid 1 seems to have had a magmatic-hydrothermal origin, while fluid 2 is probably surface-derived (meteoric water?). An alkaline, F-poorer and diluted equivalent of fluid IA was interpreted to have caused the episyenitization of the granite host rock as well as the formation of phengite-rich greisen 3. The continuos interaction of this fluid with the potassic episyenite produced a moderate- to high-salinity (20–24 wt.% NaCl eq.), low-temperature (200–100 °C) fluid (H2O–NaCl–CaCl2 ± KCl), leading to the formation of chlorite-rich zone of greisen 3 and late silicification of potassic episyenite. greisen 1, decreasing F-activity and increasing oxygen fugacity, as the system cooled down, favored the formation of a topaz-rich inner zone, which grades into a siderophyllite-rich zone outwardly. Greisen 2 was formed under more oxidizing conditions by fluids poorer in F than those trapped in the siderophyllite-rich zone. idation of aqueous-carbonic fluid took place at three distinct stages: (i) below the FMQ buffer; (ii) between the FMQ and NNO buffers; and (iii) above the NNO buffer. ssolution cavities generated during the episyenitization process increased the permeability of the altered rocks, resulting in an increase of the fluid/rock ratios at the potassic episyenite and greisen 3 sites. ese fluids were trapped under pressure conditions of <1.0 kbar, representing shallow crustal levels and are consistent with those that have been estimated for the Pitinga tin–granites. ygen fugacity, F-activity gradients and salinity variations that occurred during the cooling of the hydrothermal system, in addition to differences in permeability, were important factors in the formation of distinct greisens. They not only controlled the fluid compositional changes, but also caused the cassiterite and sulfide precipitation at the greisen sites.