Protection measures for selected ITER magnet system off-normal conditions

The International Thermonuclear Experimental Reactor (ITER) magnet systems provide the magnetic field intensity and field geometry to contain and control plasma during the various phases of pulsed operation. During these pulses, the toroidal field (TF) coils operate with a constant current. The central solenoid (CS) and poloidal field (PF) coils, on the other hand, are each independently powered. The maximum terminal voltages during plasma operation and protective discharges are 15 kV for CS and 10 kV for TF and PF. The energy stored in the 20 TF coil system is 103 GJ; in each of the other coils it is approximately 10 GJ or less. This paper describes the protection requirements and selected design concepts being considered for the large superconducting coils for the ITER. Ground faults, short circuits and helium leaks are the major serious accidents to be prevented in the coils. All coils use a solid insulation system to avoid ground faults. The electrical circuits including coil and power supply are grounded through resistors that limit current in the event of a ground fault. In the case of a short circuit within the coil winding, a large energy would be dissipated close to the small shorted volume. The impact of the short circuit can be reduced by using a potential screen. Inside the cryostat, helium leakage is most likely at the electrical insulating breaks in the cryogenic cooling lines between the coils and helium manifolds. A double containment (metallic shield and glass-epoxy) is therefore provided for the insulation breaks to allow for the detection of small leaks and to limit the spread of helium to other locations.