Sediment transportation and deposition by rain-triggered lahars at Merapi Volcano, Central Java, Indonesia

A lahar is a general term for a rapidly flowing mixture of rock debris and water (other than normal streamflow) from a volcano and refers to the moving flow. Located in the populated area of Central Java, the stratovolcano Merapi (2965 m) is prone to lahar generation, due to three main factors: (1) millions of cubic meters of pyroclastic deposits are the product of frequent pyroclastic flows, which have occurred on 2- to 4-year intervals; (2) rainfall intensity is high (often 40 mm in 2 h on average) during the rainy season from November to April; and (3) drainage pattern is very dense. Following the 22 November 1994 eruption of Merapi, 31 rain-triggered lahar events were recorded in the Boyong River between December 1994 and May 1996. apiʹs slopes, instantaneous sediment concentration at any given time of the lahars varies widely over time and space. Lahars are transient sediment-water flows whose properties are unsteady, so that the sediment load fluctuates during the flow. The boundary between the flow types (debris flow, with sediment concentration >60% volume, or hyperconcentrated flow, with sediment concentration ranges from 20% to 60% volume) may fluctuate within the flow itself. Grain-size distribution, physical composition of sediments, shear stress, yield stress, and water temperature play each a role on this boundary. Natural self-damming and rapid breakout are partly responsible for the sediment variations of the flows. -flow phases at Merapi typically last a few minutes to 10 min, and are often restricted to the lahar front. Debris-flow surges are sometimes preceded and always followed by longer hyperconcentrated flow phases. As a result, mean sediment concentration of the lahars is low, commonly from 20% to 50% volume. Besides, transient normal streamflow phases (sediment concentration <20% volume) can occur between two debris-flow surges. diment load and frequent transient flows in the Merapi channels may result from at least three factors: (1) several breaks-in-slope along the channel increase the deposition rate of sediment, and hinder the bulking capacity of the lahars; (2) source material is mainly coarse debris of “Merapi-type” block-and-ash flows. Consequently, the remobilization of coarse debris is more difficult and the clast deposition is accelerated; (3) variations of rainfall intensity over time and space, common in tropical monsoon rainfall, also influence the sediment load variations of the lahars. ntologic analyses of the lahar deposits in the Boyong River at Merapi encompass clast-supported and matrix-supported debris-flow deposits, hyperconcentrated flow deposits, and streamflow deposits. The stratigraphic succession of massive and stratified beds observed immediately after any given lahar event in the Boyong River indicates that the sediment concentration varies widely over time and space during a single lahar event. Sedimentation rate varies from 3 to 4.5 cm/min during relatively long-lived surges to as much as 20 cm/min during short-lived surges. These results indicate that the sediment load fluctuates during lahar flow, further demonstrating that lahars are transient sediment-water flows with unsteady flow properties.