Author/Authors :
ANTONINI, Gicelio Univ. of L’Aquila - UAq EMC Laboratory - Dept of Electrical Engineering, ITALY , Di CLERICO, Marc Univ. of L’Aquila - UAq EMC Laboratory - Dept of Electrical Engineering, ITALY , ORLANDI, Antonio Univ. of L’Aquila - UAq EMC Laboratory - Dept of Electrical Engineering, ITALY , RICCHIUTI, Vittorio TechnoLabs S.p.A. ss. 17,loc. Boschetto, ITALY , PASSACANTANDO, Maurizio University of L’Aquila - Department of Physics, ITALY , SANTUCCI, Sandro University of L’Aquila - Department of Physics, ITALY
Abstract :
This paper illustrates the design steps of a printed circuit board used as test vehicles for the measurement of the electrical properties of carbon nanotube’s deposit. The board has been built and used for the measurements. The measured data are post-processed in order to extract the required properties of the only nanotubes. An equivalent circuit is extracted for further use in EDA simulators and the IEEE P1597 Standard is used to compare the results.
