Title of article :
Optimization of Injection Moulding Process Parameters in the Moulding of High Density Polyethylene (HDPE)
Author/Authors :
osarenmwinda, jo university of benin - faculty of engineering - department of production engineering, Benin City, Nigeria , olodu, dd university of benin - faculty of engineering - department of production engineering, Benin City, Nigeria
Abstract :
In this study, optimal injection moulding conditions for minimum shrinkage during moulding of High Density Polyethylene (HDPE) were obtained by Taguchi method. The result showed that melting temperature of 190OC, injection pressure of 55 MPa, refilling pressure of 85 MPa and cooling time of 11 seconds gave minimum shrinkage for High Density Polyethylene. Cooling time was found to be the factor with most significant effect on the shrinkage of High Density Polyethylene followed by refilling pressure. Injection pressure was found to be the least effective factor.
Keywords :
High Density Polyethylene (HDPE) , Injection Moulding , Process Parameters , Taguchi method
Journal title :
Journal of Applied Sciences and Environmental Management
Journal title :
Journal of Applied Sciences and Environmental Management
