Title of article
Experimental Design and Performance Analysis in Plasma Arc Surface Hardening
Author/Authors
ISMAIL, MOHD IDRIS SHAH Universiti Putra Malaysia - Faculty of Engineering - Department of Mechanical and Manufacturing Engineering, Malaysia , TAHA, ZAHARI university of malaya - Faculty of Engineering - Department of Engineering Design and Manufacture, Malaysia , ABDUL SHUKOR, MOHD HAMDI university of malaya - Faculty of Engineering - Department of Engineering Design and Manufacture, Malaysia
From page
57
To page
75
Abstract
In this paper, the experimental design by using the Taguchi method was employed to optimize the processing parameters in the plasma arc surface hardening process. The evaluated processing parameters are arc current, scanning velocity and carbon content of steel. In addition, the significant effects of the relation between processing parameters were also investigated. An orthogonal array, signal-to-noise (S/N) ratio and analysis of variance (ANOVA) were employed to investigate the effects of these processing parameters. Through this study, not only the increasing in hardened depth and improvement in surface roughness, but the parameters that significantly affect on the hardening performance were also identified. Experimental results showed the effectiveness of this approach.
Keywords
Plasma arc , hardened depth , surface roughness , Taguchi method , ANOVA , optimization
Journal title
Jurnal Teknologi :F
Journal title
Jurnal Teknologi :F
Record number
2715721
Link To Document