Evaluating skid resistance of different asphalt concrete mixes

At all stages of pavement life, the highway surface should have some sort of roughness to facilitate friction between car wheels and pavement surface. Skid resistance is a measure of the resistance of pavement surface to sliding or skidding of the vehicle. It is a relationship between the vertical force and the horizontal force developed as a tire slides along the pavement surface. The texture of the pavement surface and its ability to resist the polishing effect of traffic is of prime importance in providing skidding resistance. Polishing of the aggregate is the reduction in microtexture, resulting in the smoothing and rounding of exposed aggregates. This process is caused by particle wear on a microscopic scale. It is a common fact that the lower the skid resistance value, the higher the percentage of the traffic accidents, especially during the wet seasons. Having a low skid resistance value at an asphalt concrete surface might be attributed to one or more of the following reasons: (1) use of higher asphalt content than recommended by the mix design procedure, (2) the Marshall mix design procedure itself, (3) used aggregate gradation, and (4) aggregate quality. To evaluate these factors, a comparative study was performed to find the British Pendulum Skid Resistance Number for a number of mixes. These mixes included, an asphalt concrete mix using local aggregate at the optimum Marshall asphalt content, mixes with 0.5% and 1.0% asphalt contents higher than Marshall optimum asphalt content, a mix designed using Superpave design procedure, a mix with steel slag to replace 30% of limestone aggregate, and a mix with stone matrix aggregate gradation. It was found that the mix with 30% slag has the highest skid number followed by Superpave, SMA, and Marshall mixes, respectively. It was also observed that increasing the asphalt content above the optimal asphalt content value decreases the skid resistance of these mixes.