Permeability Evolution During Non-linear Viscous Creep of Calcite Rocks

Permeability, storage capacity and volumetric strain were measured in situ during deformation of hot-pressed calcite aggregates containing 10, 20, and 30 wt% quartz. Both isostatic and conventional triaxial loading conditions were used. The tests were performed at confining pressure of 300 MPa, pore pressures between 50 to 290 MPa, temperatures from 673 to 873 K and strain rates of 3 · 10)5 s)1. Argon gas was used as the pore fluid. The initial porosities of the starting samples varied from 5% to 9%, with higher porosity correlated to higher quartz content. Microstructural observations after the experiment indicate two kinds of pores are present: 1) Angular, crack-like pores along boundaries between quartz grains or between quartz and calcite grains and 2) equant and tubular voids within the calcite matrix. Under isostatic loading conditions, the compaction rate covaries with porosity and increases with increasing effective pressure. Most of the permeability reduction induced during compaction is irreversible and probably owes to plastic processes. As has been found in previous studies on hot-pressed calcite aggregates, permeability, k, is nonlinearly related to porosity, /. Over small changes in porosity, the two parameters are approximately related as k / /n. The exponent n strongly increases as porosity decreases to a finite value (from about 4 to 6% depending on quartz content), suggesting a porosity percolation threshold. When subjected to triaxial deformation, the calcite-quartz aggregates exhibit shearenhanced compaction, but permeability does not decrease as rapidly as it does under isostatic conditions. During triaxial compaction the exponent n only varies between 2 and 3. Non-isostatic deformation seems to reduce the percolation threshold, and, in fact, enhances the permeability relative to that at the same porosity during isostatic compaction. Our data provide constraints on the governing parameters of the compaction theory which describes fluid flow through a viscous matrix, and may have important implications for expulsion of sedimentary fluids, for fluid flow during deformation and metamorphism, and melt extraction from partially molten rocks.