Elastic response of human iliac arteries in-vitro to balloon angioplasty using high-resolution CT

Previous angioplasty studies have used angiography and intravascular ultrasound to obtain vascular dimensions. These imaging methods do not always provide reliable measurements due to limitations in image orientation and resolution. In this study, high-resolution (0.1×0.1×0.5 mm) transverse CT slices were obtained from human common-iliac arteries in vitro to study their elastic response pre- and post-angioplasty. Seven iliacs from five patients were imaged over the physiological pressure range both pre- and post-angioplasty. Contrast was obtained with humidified air surrounding the artery. Angioplasty was done with 10 or 12 mm diameter Medi-Tech balloon catheters with a balloon pressure of 300 kPa held for 30 s. Lumen cirumference, c, measured from the images, was plotted against pressure, P, and curve fitting showed c=A(1−e-KP)+B where A, K, and B are fitting parameters. Six lesions appeared soft and were compressed, while one was calcified and partially lifted off the wall. Normalized changes in parameters B and K were much higher post-angioplasty in the calcified lesion, and were over 3 standard deviations from the means of the normalized changes in the six compressed lesions. Balloon/stenosed lumen diameter ratios greater than 1.2 produced a lumen area increase of 38.6±4.1%(S.D.)(n=3); ratios less than 1.2 produced an increase of 4.4±5.1%(S.D.)(n=4). There was no correlation between area increase and balloon/normal lumen diameter ratio (the value used clinically). Arteries with lesions containing stiffer plaques that tear from the artery wall during angioplasty appear more distensible over the physiological pressure range postangioplasty.