Effects of short cracks produced at blunted pre-crack tip on stress and strain distributions

The present work investigates problems: (1) How are the plastic strain and the stress (triaxiality) re-distributed after a short crack initiated, extended and blunted at the pre-crack tip? (2) How do the above changes put a crucial effect on the triggering of the cleavage fracture? Based on the previous observations of configuration changes and fracture surfaces of pre-crack tips, Finite element method (FEM) simulations of a short crack initiated, extended and blunted at a pre-crack tip and calculations of distributions of stress, strain and triaxiality are carried out for 3PB pre-cracked HSLA steel specimens tested at −130◦C. The results reveal that: as long as the fatigue pre-crack is only blunted, in its vicinity a region where the accumulated strain is sufficient to nucleate a crack, and a region where the stress (triaxiality) is sufficient to propagate a crack nucleus are separated by a distance. The nucleated crack cannot be propagated and the cleavage fracture cannot be triggered. While a short crack produced at the fully blunted fatigue pre-crack, the strain retains, the stress (triaxiality) is rebuilt. An initiated and significantly extended and then blunted short crack makes a tip configuration, which on one hand is much sharper than that of the fully blunted original pre-crack tip, on other hand is wide enough to spread its effects into the high stress covered region. This sharpened crack tip configuration re-builds a ‘sharper’ distribution of stress (triaxiality) and makes two regions metioned above closer. Finally the two regions overlap each other and a cleavage crack can be initiated and propagated at a distance ahead of the blunted fatigue pre-crack.