Adhesion improvement of SBR rubber by treatment with trichloroisocyanuric acid solutions in different esters

Ethyl, propyl and butyl acetates (EA, PA, BA, respectively) were used as solvents for trichloroisocyanuric acid (TCI) to chlorinate styrene-butadiene rubber (SBR). Characterization of the treated surfaces was carried out using ATR-IR spectroscopy, scanning electron microscopy (SEM), and contact angle measurements. Stress-strain measurements were also carried out to determine the mechanical properties of the treated rubber. Adhesion properties were studied using a polyurethane adhesive and the failed surfaces obtained after performing T-peel tests were analyzed in order to precisely locate the joint failure. The results showed that the solvent is a key factor in the effectiveness of the chlorination of R2 rubber. The solvents with slower evaporation rate led to more pronounced modifications on the R2 rubber surface. But these solvents could favour the migration of wax from the bulk rubber to the surface creating a weak antiadherent layer that prevented adhesion. The increase in TCI percentage in the chlorinating solution produced more marked modifications on the R2 rubber surface, avoiding the migration of wax. The solvent in the chlorinating solution also affects the effectiveness of the zinc stearate elimination from the R1 rubber surface; however, good adhesion was obtained even though this compound was not completely removed, indicating that the presence of zinc stearate in the rubber formulation did not produce a detrimental effect in the adhesion of SBRs.