An experimental investigation on thermal striping: Mixing phenomena of a vertical non-buoyant jet with two adjacent buoyant jets as measured by ultrasound Doppler velocimetry Original Research Article

An experimental investigation on the thermal mixing phenomena of three quasi-planar vertical jets, with the central jet at a lower relative temperature than the two adjacent jets, was conducted. The central jet was unheated (‘cold’), while the two adjacent jets were heated (‘hot’). The temperature difference and velocity ratio between the heated (h) and unheated (c) jets were, ΔThc=5°C, 10°C and r=Vcold,exit/Vhot,exit=1.0 (isovelocity), 0.7, 0.5 (non-isovelocity) respectively. The typical Reynolds number was ReD=1.8×104, where D is the hydraulic diameter of the exit nozzle. Velocity measurement of a reference single-jet and triple-jet arrangement were taken by ultrasound Doppler velocimetry (UDV) while temperature data were taken by a vertically traversed thermocouple array. Our UDV data revealed that, beyond the exit region, our single-jet data behaved in the classic manner. In contrast, the triple-jet exhibited, for example, up to 20 times the root-mean-square velocity values of the single-jet, especially in the regions in-between the cold and hot jets. In particular, for the isovelocity case (Vexit=0.5 m/s) with ΔThc=5°C, we found that the convective mixing predominantly takes place at axial distances, z/D=2.0–4.5, over a spanwise width, x/D∼|2.25|, centered about the cold jet. An estimate of the turbulent heat flux distribution semi-quantitatively substantiated our results. As for the non-isovelocity case, temperature data showed a localized asymmetry that subsequently delayed the onset of mixing. Convective mixing however, did occur and yielded higher post-mixing temperatures in comparison to the isovelocity case.