Phase variation experiments in non-contact dynamic force microscopy using phase locked loop techniques

This work presents constant amplitude Dynamic Force Microscopy DFM.measurements under ultra-high vacuum conditions performed with home-built digital electronics based on the principle of phase locked loop PLL.techniques. In DFM so-called topography is often measured in constant frequency shift D f.mode. This study describes the influence of phase shifts on constant D f imaging. Therefore, phase variation experiments were acquired, leading to information about the cantilever resonance behaviour close to the surface. As sample, an evaporated thin film of NaCl on a Cu 111.substrate was chosen in order to obtain a heterogeneous system with clean Cu and NaCl areas. The atomic structure of both materials was resolved, which is the first time true atomic resolution was obtained on a metal. Large apparent topography variations are observed on this heterogeneous sample when changing the phase between the excitation and oscillation of the cantilever end. Such artefacts can be explained by comparison with phase variation experiments. q1999 Elsevier Science B.V. All rights reserved.