DocumentCode
1055167
Title
Ribbon-form sendust alloy
Author
Tsuya, Noboru ; Arai, Ken-Ichi ; Ohmori, Kenji
Author_Institution
Tohoku University, Sendai, Japan.
Volume
15
Issue
4
fYear
1979
fDate
7/1/1979 12:00:00 AM
Firstpage
1149
Lastpage
1153
Abstract
Ribbon samples near the Sendust composition 
Fe, 
Si, 
Al (9.12 wt% 
wt%, 4.88 wt% 
wt%) were prepared by rapid quenching techniques. The ribbons were about 40 μm in thickness, 2 mm in width, and 20 m in length. These ribbons were flexible, and it was possible to wind them around a rod 15 mm diameter, The density and Vickers hardness were 6.4 g/cm3and 560, respectively. Their electrical resistivity was 88μΩ. cm after annealing. The coercive field Hc and the initial permeability μi in a straight ribbon of composition 84.9 Fe, 9.62 Si, 5.48 Al were 24 mOe and 30 000 after annealing.
Fe, Si, Al (9.12 wt% wt%, 4.88 wt% wt%) were prepared by rapid quenching techniques. The ribbons were about 40 μm in thickness, 2 mm in width, and 20 m in length. These ribbons were flexible, and it was possible to wind them around a rod 15 mm diameter, The density and Vickers hardness were 6.4 g/cm3and 560, respectively. Their electrical resistivity was 88μΩ. cm after annealing. The coercive field HKeywords
Magnetic recording/reading heads; Soft magnetic materials/devices; Aluminum; Frequency; Iron; Magnetic flux; Magnetic recording; Magnetostriction; Permeability; Saturation magnetization; Silicon; Soft magnetic materials;
fLanguage
English
Journal_Title
Magnetics, IEEE Transactions on
Publisher
ieee
ISSN
0018-9464
Type
jour
DOI
10.1109/TMAG.1979.1145880
Filename
1145880
Link To Document