Partial discharges in a cavity embedded in oil-impregnated paper: effect of electrical and thermal aging

In this paper, the rapid aging due to Partial Discharge (PD) activity was investigated in unaged and thermally aged oil-impregnated paper with a disk-shaped cavity between the sheets of paper. The PD inception voltage and the voltage for instantaneous breakdown were measured, and the time to breakdown was measured by applying voltages less than the instantaneous breakdown voltage. A comparison between time to breakdown of unaged and thermally aged paper shows no significant difference between thermally aged and unaged paper at sustaining PD activity. The time to breakdown as a function of applied electric field was plotted and compared for both cases showing points scattered around a line in log-log scale. Changes of the PD parameters, such as PD magnitude and PD repetition rate were analyzed from the beginning of PD activity up to the moment of breakdown. The results show that the number and magnitude of PD increase at the beginning of aging until they reach to a maximum value, then both quantities decrease slowly over time until the final puncture breakdown occurs. The results emphasize the importance of PD monitoring on real equipment with oil-impregnated paper as insulation system, such as power transformers, since a focus on the number and magnitude of PD at just the present time may mislead the interpretation. Dielectric spectroscopy measurements performed on unaged and thermally aged paper showed an increasing trend of ε" after the sheets of paper were exposed to thermal aging for longer time. Dielectric spectroscopy measurements performed on samples before and after exposure to PD activity showed a big change of ε", This change can be attributed to byproducts and ions produced by PD activity.